Sebo makes changing the vacuum bag on their canister
vacuum very simply.
First make sure the power cord is disconnected from
the wall outlet Then letting the cord retract all
the way back in to the Vacuum cleaner.
Disconnect the hose assy from the canister unit and
tip up the vacuum cleaner so it sitting on its end
as it shows in the diagram on the left this will
give you easy access to the bag compartment.
Now pull out on the bag door release latch to the
open position tilt the bag coover door out from the
mail body and lift out. This is a good time to insert
the little green disc thats is supplied in the box of
bags into the vacuum bag dirt intake hole keeping dirt
and fine dust from spilling out.
Squeeze the clamps on both sides of the vacuum bag green
sealing plate and slide the bag off of the bag docking bracket
and dispose of the old vacuum bag into a trash bin
At this time you are ready to put on the new vacuum bag
take the new bag and line the bag geen sealing plate with
the bag docking bracket and slide on until it locks in to place
Now you are ready to put the vacuum bag cover door back on
at a slight angle line up the the lower bag cover door with
the slots in the main vacuum and making sure the bag door latch
is still in the open position tilt the bag door in and push the
bag door latch now back to the locking position
Tilt your vacuum cleaner back down to operating position connect
your hose back to the main canister and your done
|
